clubhwa.blogg.se

Remove any adhesive from the camera cable connector.ĭisconnect the camera cable by pulling the male end out of its socket, parallel to the logic board, do not lift it upwards. Disconnect the camera cable by pulling the male end out of its socket, parallel to the logic board, do not lift it upwards.Remove any adhesive from the camera cable connector.Use the tip of a spudger to lift the left fan connector straight up from its socket on the logic board. Use the tip of a spudger to lift the left fan connector straight up from its socket on the logic board.It is useful to twist the spudger axially from beneath the fan cable wires to release the connector. Use the tip of a spudger to lift the right fan connector straight up from its socket on the logic board.īe sure to only pry up on the connector itself not on the socket or you may damage the machine. It is useful to twist the spudger axially from beneath the fan cable wires to release the connector.Be sure to only pry up on the connector itself not on the socket or you may damage the machine.Use the tip of a spudger to lift the right fan connector straight up from its socket on the logic board.Remove the following six screws securing both the right fan and the left fan to the logic board: Remove the following six screws securing both the right fan and the left fan to the logic board:.Lift the mid wall out of the upper case.Remove the following 5 screws securing the mid wall to the upper case: Remove the following 5 screws securing the mid wall to the upper case:.

Using both hands, lift and remove the lower case off the upper case. Using both hands, lift and remove the lower case off the upper case.Remove the following eight screws securing the lower case to the chassis: Remove the following eight screws securing the lower case to the chassis:.If the latch is depressed it will lock the battery in place. Grab the translucent plastic tab and pull the battery up and out of the Unibody. If the latch is depressed it will lock the battery in place.īe sure the access door release latch is vertical before proceeding.Grab the translucent plastic tab and pull the battery up and out of the Unibody.Be sure the access door release latch is vertical before proceeding.The access door should now be raised enough to lift it up and out of the Unibody. The access door should now be raised enough to lift it up and out of the Unibody.Lift the release latch until it is vertical. With the case closed, place the Unibody top-side down on a flat surface.ĭepress the grooved side of the access door release latch enough to grab the free end.